9/3/2023 0 Comments Baby change tableCosts resulting from the installation or removal of defective products are not covered under this warranty. If any product or part proves to be defective within 12 months from date of shipment from the factory it will be repaired or replaced without any charge including freight costs when authorized. Failure to comply to proper installation procedure will void warranty and may result in malfunctioning or injury. All installations must be fully inspected and approved by property owners and maintenance personnel prior to product being put into use. Mounting hardware and other systems to be determined by contractor and installer pending specific structure, design, and conditions. Installers must consult and comply with local building codes. The baby changing station must be installed by qualified trades persons. For replacement parts please contact 1 (800) 667-5094. Check all hardware and components monthly or as required by site usage to ensure hardware is tight and there are no missing or damaged pieces. After the cleaning agent is applied, wipe off with a clean soft cloth or sponge. When using any type of cleaning solution, spray onto a discrete area to test before full usage. For general dirt and blemishes on painted steel or plastic use warm water and mild soap, or a general mild cleaning solution. Do not use harsh detergents or chemical cleaners. Approved stainless steel cleaner may be used to clean scuffs or fingerprints on stainless surfaces. Products should be wiped down with a damp soft cloth periodically. Normal preventative maintenance and cleaning will keep Frost products functioning properly and may extend normal product life. We recommend installation be completed by a qualified tradesperson. The change station is no stronger than the anchors or walls to which they are attached and, therefore, must be firmly secured in order to support the weight they are intended to support. Warning: a stud must be located and used for at least one side of the changing station. Unit comes with four 3” wood screws, four ¾” finishing washers, two 3” machine screws, four ¾” flat washers, two toggle anchors, six 1 ¼” caps, and one door/wall plate. For unrestricted access, bottom of unit to floor must be between 38.1cm and 121.9cm (15” to 48”). Door Open: 87.4cm W x 44.5cm D x 44.5cm H (34.4” W x 17.5” D x 17.5”H)įor complete installation instructions please see specification page or the instructions within the packaging of your unit.Finally, the 1125 change station is compliant to applicable sections of CPSIA. The product meets of exceeds ASTM G22 Anti-Fungal with no measurable fungal growth. The product meets or exceeds ASTM G21 Anti-Bacterial with no measurable bacterial growth. The product meets or exceeds ASTM F2285 safety specifications for weight for commercial baby changing stations. Warning labels in English, French, and Spanish. sections: 3 – Knee Clearance 2 – Maximum Protruding Objects 2 – Froward Reach 3 – Side Reach 4 – Operation 3 – Work Surface This unit also has ANSI Z535.2 and Z535.4 complaint safety labels. If mounted correctly the product is compliant to the following A.D.A. The recommended mounting height for A.D.A. The safety strap can also by operated by one hand, meeting A.D.A. standards due to its slim profile of 10.2cm (4”) when closed. Intended for children 3.5 years old and under and weighing less than 50 lbs.įrost code 1125 is designed to be easy to use and operate while not sacrificing child safety.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |